In-Vehicle Servicing: Flexplate: Installation
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Position the flexplate.
- Using the special tool, install the bolts in the sequence shown, in 3 stages.
- Stage 1: Tighten to 50 Nm (37 lb-ft).
- Stage 2: Tighten to 80 Nm (59 lb-ft).
- Stage 3: Tighten to 112 Nm (83 lb-ft).
- Install the transmission. For additional information, refer to AUTOMATIC TRANSMISSION - 5R44E AND 5R55E article.
NOTE:
Engine balancing is not required. Balance weights should not be installed on the new flexplate.
NOTE:
Special bolts are used for installation. Do not use standard bolts.