LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 872 (Driveshaft) >> Disassembly And Assembly >> Driveshaft Universal Joint - Single Carden, Slip Yoke >> Assembly >> Opposite bearing cup installation

Opposite bearing cup installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Repeat Bearing cup installation in this procedure to install the new bearing cup and snap ring on the opposite side of the shaft yoke.
    2. Fig 1: Installing New Bearing Cup And Snap Ring On Opposite Side Of Shaft Yoke
    GF0006255Courtesy of FORD MOTOR CO.
  2. Remove the shaft from the special tool, and install the new snap ring.
    Fig 2: Identifying Snap Ring
    GF0000800Courtesy of FORD MOTOR CO.
    3. CAUTION: Do not strike the bearings.
    Fig 3: Locating U-Joint
    GF0006256Courtesy of FORD MOTOR CO.
  3. Check the U-joint for freedom of movement.
    • If binding, strike the yoke with a brass or plastic hammer.
scientia non olet · About LEMON Manuals