LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 872 (Driveshaft) >> Disassembly And Assembly >> Driveshaft Universal Joint - Single Carden, Slip Yoke >> Assembly >> Bearing cup installation

Bearing cup installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Install the Universal Joint Kits as complete assemblies only. Do not mix components from other kits.
  1. Install a new spider and bearing cup.
    1. Start a new bearing cup in the shaft yoke.
      • Check the needle bearings for correct positioning.
    2. Position the new spider in the shaft yoke.
    3. Press the bearing cup to just below the snap ring groove.
      Fig 1: Pressing Bearing Cup To Just Below Snap Ring Groove
      GF0006254Courtesy of FORD MOTOR CO.
    2. NOTE: Use the yellow snap rings supplied in the kit to assemble the universal joint (U-joint). If difficulty is encountered with the yellow snap rings, install the black snap rings.
    Fig 2: Locating Snap Ring
    G03883359Courtesy of FORD MOTOR CO.
  2. Remove the shaft from the special tool, and install the new snap ring.
scientia non olet · About LEMON Manuals