LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 872 (Driveshaft) >> Disassembly And Assembly >> Driveshaft Universal Joint - Single Carden, Flange Yoke >> Disassembly >> Initial disassembly

Initial disassembly

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not, under any circumstance, clamp the driveshaft in the jaws of a vise or similar holding fixture. Denting or localizing fracture can result, causing driveshaft failure during vehicle operation.
  1. Place the driveshaft on a suitable workbench. Do not damage the tube.
    2. NOTE: If components are not marked and installed incorrectly, driveline imbalance can occur.
    Fig 1: Locating Index-Mark Driveshaft Components
    GF0006261Courtesy of FORD MOTOR CO.
  2. Index-mark the driveshaft components.
  3. Remove and discard the 4 snap rings.
    Fig 2: Locating Snap Rings
    GF0006262Courtesy of FORD MOTOR CO.
  4. Clamp the special tool in a vise.
    Fig 3: Clamping Special Tool In Vise
    GF0009713Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals