LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 872 (Driveshaft) >> Disassembly And Assembly >> Driveshaft Universal Joint - Single Carden, Flange Yoke >> Assembly >> Flange installation

Flange installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the flange. Install a new flange, if necessary.
  2. Install the new bearing cups and the flange.
    Fig 1: Installing Bearing Cups & Flange
    GF0006266Courtesy of FORD MOTOR CO.
    1. Start a new bearing cup in the flange.
      • Check the needle bearings for correct positioning.
    2. Position the flange on the spider.
    3. Position the assembly in the special tool.
    4. Press the bearing cup to just below the snap ring groove.
    • Repeat to install the new bearing cup on the opposite side of the flange.
scientia non olet · About LEMON Manuals