Final assembly

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Use the yellow snap rings supplied in the kit to assemble the universal joint (U-joint). If difficulty is encountered with the yellow snap rings, install the black snap rings.

Fig 1: Locating Black Snap Rings

Courtesy of FORD MOTOR CO.

Remove the driveshaft from the special tool, and install the 4 new snap rings.

CAUTION: Do not strike the bearings.

Fig 2: Checking U-Joint For Freedom Of Movement

Courtesy of FORD MOTOR CO.

Check the U-joint for freedom of movement.
- If binding, strike the yoke with a brass or plastic hammer.