LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 872 (Driveshaft) >> Disassembly And Assembly >> Driveshaft Universal Joint - Single Carden, Flange Yoke >> Assembly >> Bearing cup installation

Bearing cup installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Install the Universal Joint Kits as complete assemblies only. Do not mix components from other kits.
    Fig 1: Installing Bearing Cup Using Special Tool
    GF0006265Courtesy of FORD MOTOR CO.
  1. Install a new spider and bearing cups.
    1. Start a new bearing cup in the driveshaft yoke.
      • Check the needle bearings for correct positioning.
    2. Position the new spider in the driveshaft yoke.
    3. Position the driveshaft yoke in the special tool.
    4. Press the bearing cup to just below the snap ring groove.
    • Repeat to install the new bearing cup on the opposite side of the driveshaft yoke.
scientia non olet · About LEMON Manuals