Axle Carrier Bushing: Removal

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Remove the axle assembly. For additional information, refer to Axle Assembly .

Fig 1: Index-Marking Housing In Line With Arrow On Special Tool (204-187)

Courtesy of FORD MOTOR CO.

Place the special tool on the insulator and index-mark the housing in line with the arrow on the special tool.

Fig 2: Measuring Gap Between Insulator Flange & Axle Housing Using Feeler Gauge

Courtesy of FORD MOTOR CO.

Using a feeler gauge, measure the gap between the insulator flange and the axle housing. Record the measurement.

Fig 3: Tapping Special Tool (204-186) On Between Axle Housing & Insulator Flange

Courtesy of FORD MOTOR CO.

Tap the special tool on between the axle housing and the insulator flange.

Fig 4: Assembling Remaining Remover Tools

Courtesy of FORD MOTOR CO.

Assemble the remaining remover tools. Remove and discard the insulator.