LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 870 (Front Drive Axle/Differential - DANA 35) >> Removal And Installation >> Axle Carrier Bushing >> Installation

Axle Carrier Bushing: Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Aligning Axle Housing Arrow Marks To Special Tool Arrow
GF0009818Courtesy of FORD MOTOR CO.
  1. Set the new insulator in the housing bore and install the special tools. Align the arrow marks on the special tool with the index mark on the axle housing.
    2. Fig 2: Measuring Gap Between Insulator Flange & Axle Housing
    GF0009819Courtesy of FORD MOTOR CO.
  2. Draw the insulator into the housing to the measured gap earlier in this procedure.
  3. Install the axle assembly. For additional information, refer to Axle Assembly .
scientia non olet · About LEMON Manuals