Both sides

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Remove the halfshafts. For additional information, refer to FRONT DRIVE HALFSHAFTS .

Fig 1: Removing Stub Shaft Oil Seals Using Special Tools (100-001) & (307-309)

Courtesy of FORD MOTOR CO.

Using the special tool and a suitable slide hammer to remove the stub shaft oil seals.

Fig 2: Removing Stub Shaft Pilot Bearings Using Special Tools (100-001) & (307-318)

Courtesy of FORD MOTOR CO.

Using the special tool and a slide hammer, remove the stub shaft pilot bearings or bushings, as equipped.
Clean the bearing and seal surfaces of any foreign material.