LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 869 (Rear Drive Axle/Differential - Ford 8.8-Inch Ring Gear High Torque) >> In-Vehicle Servicing >> Rear Wheel Bearing and Axle Shaft Seal >> Removal

Rear Wheel Bearing and Axle Shaft Seal: Removal

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the axle shaft. For additional information, refer to Axle Shaft .
    2. NOTE: If only a new seal needs to be installed, use care to avoid damaging the seal bore.
  2. Using a suitable seal remover, remove the axle shaft oil seal. Discard the oil seal.
  3. Inspect the rear wheel bearing and axle shaft for wear or damage.
    4. Fig 1: Using Special Tools (100-001) & (205-219) To Remove Rear Wheel Bearing
    GF0009721Courtesy of FORD MOTOR CO.
  4. If necessary, using the special tools, remove the rear wheel bearing.
scientia non olet · About LEMON Manuals