General Specifications
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Backlash between differential ring gear and pinion teeth | 0.203-0.304 mm (0.008-0.012 in) |
| Initial minimum break away torque, Traction-Lok® | 27 N.m (20 lb-ft) |
| Maximum axle shaft end play | 0.762 mm (0.030 in) |
| Maximum differential case runout | 0.076 mm (0.003 in) |
| Maximum differential ring gear backlash variation between teeth | 0.102 mm (0.004 in) |
| Maximum pinion runout | 0.25 mm (0.010 in T.I.R.) |
| RABS sensor air gap | 0.127-1.143 mm (0.005-0.045 in) |
| Pinion bearing preload | 1.8-3.3 N.m (16-29 lb-in) |
| Rear axle lubricant level | 6.4 mm (0.25 in) to 14.3 mm (0.57 in) from the bottom of the fill hole |