Differential Carrier: Removal
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the axle shafts. For additional information, refer to Axle Shaft .
- Remove the 4 differential bearing cap bolts and the 2 differential bearing caps.
- Using pry bars and wood blocks, remove the differential carrier assembly from the axle housing.
NOTE:
Index-mark the position of the differential bearing caps, as arrows may not be visible. The differential bearing caps must be installed in their original locations and positions.
CAUTION:
Place a wood block between the pry bar and the axle housing to protect the machined surface from damage.
NOTE:
Index-mark the position of the differential bearing shims. The differential bearing shims must be installed in their original locations and positions.