LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 867 (Rear Drive Axle/Differential - Ford 7.5-Inch Ring Gear) >> In-Vehicle Servicing >> Rear Wheel Bearing and Axle Shaft Seal >> Installation

Rear Wheel Bearing and Axle Shaft Seal: Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the new rear wheel bearing with lubricant.
  2. Using the special tools, install the rear wheel bearing.
    3. Fig 1: Installing Rear Wheel Bearing Using Special Tools (205-124) & (205-153)
    GF0009722Courtesy of FORD MOTOR CO.
  3. Lubricate the lip of the new wheel bearing oil seal with grease.
    4. Fig 2: Installing Wheel Bearing Oil Seal Using Special Tools (205-390) & (205-153)
    GF0009723Courtesy of FORD MOTOR CO.
  4. Using the special tools, install the wheel bearing oil seal.
  5. Install the axle shaft. For additional information, refer to Axle Shaft .
scientia non olet · About LEMON Manuals