LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 867 (Rear Drive Axle/Differential - Ford 7.5-Inch Ring Gear) >> In-Vehicle Servicing >> Drive Pinion Seal >> Removal

Drive Pinion Seal: Removal

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the pinion flange. For additional information, refer to Drive Pinion Flange .
    2. Fig 1: Removing Drive Pinion Oil Seal
    G03878521Courtesy of FORD MOTOR CO.
  2. Pry up on the metal flange of the rear axle drive pinion seal. Install gripping pliers and strike with a hammer until the rear axle drive pinion seal is removed.
scientia non olet · About LEMON Manuals