LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 867 (Rear Drive Axle/Differential - Ford 7.5-Inch Ring Gear) >> In-Vehicle Servicing >> Drive Pinion Seal >> Installation

Drive Pinion Seal: Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the lips of the new rear axle drive pinion seal with grease.
    2. Fig 1: Using Special Tool (205-208) To Install New Rear Axel Drive Pinion Seal
    GF0003073Courtesy of FORD MOTOR CO.
    NOTE: If the rear axle drive pinion seal becomes misaligned during installation, remove the rear axle drive pinion seal and install a new seal.
  2. Using the special tool, install the rear axle drive pinion seal.
  3. Install the pinion flange. For additional information, refer to Drive Pinion Flange .
scientia non olet · About LEMON Manuals