LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 865 (Front Disc Brake System) >> Removal And Installation >> Front Disc Brake >> Installation >> RWD vehicles

RWD vehicles

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the inner and outer wheel bearings, the brake disc and hub race with metal brake parts cleaner. Inspect for damage or wear.
  2. Lubricate the inner and outer wheel bearings, the brake disc and hub race with premium long-life grease.
  3. Install the inner wheel bearing into the brake disc hub.
  4. Install a new wheel hub grease seal.
  5. Position the brake disc and hub onto the spindle.
  6. Install the outer wheel bearing, outer wheel bearing retaining washer and the hub spindle nut.
  7. Tighten the spindle nut while rotating the brake disc and hub.
    • Tighten to 29 Nm (21 lb-ft).
  8. Loosen the spindle nut 175 degrees.
  9. Tighten the spindle nut while rotating the brake disc and hub.
    • Tighten to 2 Nm (18 lb-in).
  10. Install the hub spindle nut retainer, the cotter pin and the hub grease cap.
scientia non olet · About LEMON Manuals