LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Electronic Engine Control System -- Diesel Engine -- F250-F550 Super Duty) >> Removal And Installation >> Exhaust Pressure Sensor - Late Build >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
  1. Turn the ignition switch to the OFF position.
  2. Disconnect the exhaust pressure sensor electrical connector.
    Fig 1: Disconnecting Exhaust Pressure Sensor Electrical Connector
    G03908128Courtesy of FORD MOTOR CO.
  3. Using a backup wrench, remove the exhaust pressure sensor.
    Fig 2: Removing/Installing Exhaust Pressure Sensor With Torque Specifications
    G03908129Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals