LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 850 (Glow Plug System - F250-F550 Super Duty 6.0L (99P F450/550)) >> Removal And Installation >> Glow Plug Module >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cables. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  2. Disconnect the pushpin retainer, injection control pressure (ICP) electrical connector and glow plug connectors.
    3. Fig 1: Locating Injection Control Pressure (ICP) Electrical Connector And Glow Plug Module Connectors
    G03906822Courtesy of FORD MOTOR CO.
  3. Remove the 2 nuts and the glow plug relay.
    • Tighten to 8 Nm (71 lb-in).
    4. Fig 2: Locating Glow Plug Module/Relay
    GF0005986Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals