LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 846 (Engine Ignition System - 5.4L And 6.8L (3V) - F250-F550) >> Removal And Installation >> Ignition Coil-On-Plug - 6.8L >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  2. Disconnect the ignition coil electrical connector.
  3. Remove the bolt and the ignition coil.
    • Remove the ignition coil, using a twisting motion while pulling up on the ignition coil.
    • To install, tighten to 6 Nm (53 lb-in).
    4. NOTE: Verify that the ignition coil spring is correctly located inside the ignition coil boot and that there is no damage to the tip of the boot.
  4. To install, reverse the removal procedure.
    • Apply a light coat of dielectric compound to the inside of the ignition coil boots.
scientia non olet · About LEMON Manuals