LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 824 (Seat System -- F250-F550 Super Duty) >> Removal And Installation >> Seat Control Switch >> Removal And Installation >> All seats

All seats

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat. For additional information, refer to Seat - Front, Bucket and 40 Percent  in this article.
  2. Remove the lumbar knob.
    Fig 1: Identifying Lumbar Knob
    GF0004990Courtesy of FORD MOTOR CO.
  3. Remove the seat backrest lever.
    Fig 2: Locating Seat Backrest Lever
    GF0004991Courtesy of FORD MOTOR CO.
  4. Remove the screws.
    Fig 3: Locating Screws
    GF0004992Courtesy of FORD MOTOR CO.
  5. Remove the pin-type retainer.
    Fig 4: Locating Pin-Type Retainer
    GF0004993Courtesy of FORD MOTOR CO.
  6. Remove the screws.
    Fig 5: Locating Screws
    GF0004994Courtesy of FORD MOTOR CO.
  7. Remove the screws.
    Fig 6: Locating Screws
    GF0004995Courtesy of FORD MOTOR CO.


  1. Disconnect the electrical connector and remove the seat control switch.
    Fig 1: Removing Seat Control Switch
    GF0004996Courtesy of FORD MOTOR CO.
  2. To install, reverse the removal procedure.