Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the cowl top vent panels. For additional information, refer to FRONT END BODY PANELS article.
Remove the wiper mounting arm and pivot shaft.
- Remove the 5 bolts.
  - To install, tighten to 11 N.m (8 lb-ft).
- Disconnect electrical connector.
- Remove the wiper mounting arm and pivot shaft assembly.

Fig 1: Removing Wiper Mounting Arm And Pivot Shaft Assembly

Courtesy of FORD MOTOR CO.

If necessary, remove the wiper motor. For additional information, refer to wiper motor in this article.
To install, reverse the removal procedure.