Throttle Body: Installation
WARNING: This page is about a different car, the 2007 Ford Pickup and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Using a new O-ring seal, install the TB and tighten the 4 bolts in 2 stages.
- Stage 1: Tighten to 9 N.m (80 lb-in).
- Stage 2: Tighten an additional 90 degrees (1/4 turn).
- Connect the TP sensor electrical connector.
- Connect the electronic throttle control electrical connector.
- Install the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
- Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.