Removal And Installation: Flywheel: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Install the flywheel.
1. Install the guide studs.
2. Install the flywheel and ring gear assembly.
3. Install the bolts.
4. Remove the guide studs. Install the bolts.
- For 6.0L engine, tighten to 93 Nm (69 lb-ft).
- For 5.4L and 6.8L engine, tighten to 80 Nm (59 lb-ft).
Fig 1: Identifying Bolts And Guide Studs - 6.0L
Courtesy of FORD MOTOR CO.

Fig 2: Identifying Bolts And Guide Studs - 5.4L And 6.8L
Courtesy of FORD MOTOR CO.
Restore the vehicle to operating condition.
1. Install the clutch disc and pressure plate. For additional information, refer to Clutch Disc and Pressure Plate in this article.
2. Install the transmission. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION - ZF 6-SPEED article.