LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 795 (Engine - 5.4L (3V) - F250 & F350) >> Disassembly And Assembly Of Subassemblies >> Intake Manifold Assembly >> Disassembly

Intake Manifold Assembly: Disassembly

WARNING: This page is about a different car, the 2007 Ford Pickup and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 4 bolts and the throttle body (TB).
  2. Remove the 4 bolts and the fuel rail.
  3. Remove the fuel injector-to-fuel rail locking clips and separate the fuel injectors from the fuel rail.
    • Discard the 2 O-ring seals from each fuel injector.
  4. Remove the vacuum tube assembly from the intake manifold.
  5. Remove the charge motion control valve (CMCV) rod locking clips.
  6. Remove the stud bolt, the 2 bolts and the CMCV.
  7. Remove the 2 bolts and the PCV heater element.
    • Discard the O-ring seal.
  8. Remove the engine noise shield insulator from the intake manifold.
scientia non olet · About LEMON Manuals