LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 794 (Electronic Engine Controls - Gasoline Engine -- F250-F550 Super Duty) >> Removal And Installation >> Cylinder Head Temperature (CHT) Sensor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the intake manifold. For additional information, refer to ENGINE - 5.4L (3V) article (5.4L) or ENGINE - 6.8L (3V) article (6.8L).
  2. Disconnect the cylinder head temperature (CHT) sensor electrical connector.
  3. Remove the CHT sensor and discard.
    • To install, tighten to 10 N.m (89 lb-in).
    • Coat the new CHT sensor threads with high temperature nickel anti-seize lubricant prior to installation.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals