LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 766 (Manual Transmission - F-150) >> Disassembly And Assembly Of Subassemblies >> Input Shaft Bearing >> Disassembly

Input Shaft Bearing: Disassembly

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove and discard the fluid scoop ring.
    2. Fig 1: Locating Fluid Scoop Ring
    GF0003944Courtesy of FORD MOTOR CO.
    CAUTION: Use of essential tools may cause damage to the bearings being removed.
    CAUTION: Hold the input shaft so it does not fall.
  2. Using the special tool, press the input shaft bearing off the input shaft. Discard the bearing.
    • Install a new bearing and cup. Install as a set only. Do not install one without the other.
    • Inspect the input shaft for wear or damage. Install a new gear as necessary.
    3. Fig 2: Locating Input Shaft Bearing
    GF0003945Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals