LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 757 (Anti-Lock Brake System - F150 & Mark LT) >> Removal And Installation >> Wheel Speed Sensor - Front, Rear Wheel Drive (RWD) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
    2. NOTE: The harness connector is located in the engine compartment secured to the fender apron.
  2. Disconnect the wheel speed sensor electrical connector.
  3. Disconnect the 2 wheel speed sensor harness retainers from the brake hose.
  4. Remove the wheel speed sensor harness from the pushpin retainer.
  5. Remove the bolt and the wheel speed sensor.
    • To install, tighten to 8 Nm (71 lb-in).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals