LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 740 (Bumper System - F150 & Mark LT) >> Removal And Installation >> Bumper Cover - Front >> Removal And Installation >> All vehicles

All vehicles

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the headlamps. For additional information, refer to EXTERIOR LIGHTING article.
    2. NOTE: The front bumper cover-to-front bumper bolts must be replaced with new bolts.
  2. Remove the front bumper cover-to-front bumper bolts.
  3. Remove the hood over-slam bumper bolts.
  4. Remove the hood over-slam bumpers.
  5. Remove the front bumper cover brace bolts.
  6. Remove the front bumper cover braces.
  7. Remove the front bumper cover-to-front fender bolts.
  8. Remove the front bumper cover pin-type retainers.


  1. Remove the bumper cover bolts located at the headlamp openings.
  2. Remove the front bumper cover.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals