Deactivating/Activating Power Door Unlock Switch Inhibit - Using the Power Door Lock Switches
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
This feature can be configured by the customer. Steps 1, 2 and 3 must be completed within 30 seconds.
- Turn the key to ON, then press UNLOCK 3 times.
- Turn the key to OFF, then press UNLOCK 3 times.
- Turn the key to ON.
- Verify that the horn chirps. This indicates the enable/disable mode is ready to receive program changes.
- Within 5 seconds press the LOCK button twice.
One horn chirp indicates the system is disabled. One horn chirp, followed by the horn sounding, indicates the system is enabled.
Pressing the lock button twice (again) toggles the door lock control switch UNLOCK button inhibit feature state.
Turn the key OFF to exit the enable/disable programming mode.