LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 726 (Seat System - F-150 & Mark LT) >> Removal And Installation >> Seat Backrest Cover - Front, 20 Percent >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 20 percent seat. For additional information, refer to Seat - Front, 20 Percent  in this article.
  2. Remove the LH side shield pin-type retainer, screw and shield.
  3. Remove the RH upper side shield screw and shield.
  4. Remove the LH backrest bracket pivot bolt and pivot bolt bushing.
    • To install, tighten to 35 Nm (26 lb-ft).
  5. Remove the 2 RH upper adjustable backrest bracket bolts and the adjustable backrest.
    • To install, tighten to 35 Nm (26 lb-ft).
  6. Unzip the armrest trim cover zipper, peal the trim cover back and remove the hog rings and the trim cover.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals