Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Windshield washer solution contains methanol, which is poisonous. Observe all cautions and warnings indicated on the label of the container. Failure to follow these instructions could result in personal injury.

CAUTION: Do not operate the windshield washer pump before filling the reservoir. Failure to do so could result in premature pump failure.

NOTE: To prevent spilling windshield washer fluid, drain fluid from the windshield washer reservoir before removal.

Disconnect the windshield washer pump electrical connector.

Fig 1: Disconnecting The Windshield Washer Pump Electrical Connector

Courtesy of FORD MOTOR CO.

Disconnect washer fluid reservoir hose.

Fig 2: Locating Washer Fluid Reservoir Hose

Courtesy of FORD MOTOR CO.

Remove the 3 washer fluid reservoir bolts.
- To install, tighten to 7 N.m (62 lb-in).
Remove the washer fluid reservoir.

CAUTION: When installing a new windshield washer pump, be careful not to damage the rubber grommet.

Remove the windshield washer pump.
To install, reverse the removal procedure.