LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 723 (Information And Entertainment Systems) >> Diagnostic Tests >> Information and Entertainment System >> Inspection and Verification >> Speaker Walk-Around Test

Speaker Walk-Around Test

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: To enter the speaker walk-around test or audio unit self-diagnostic mode, the audio unit must be turned on and in radio tuner mode (AM/FM).
  1. To enter the speaker walk-around test, simultaneously press the audio unit preset buttons 3 and 6.
  2. The speaker walk-around test applies sound to each speaker for approximately 1-2 seconds. Each speaker is tested and displayed on the audio unit in the following sequence: RF, LF, LR, RR, and SUBWOOFER (if equipped).
  3. To exit the speaker walk-around test, turn the key to OFF or turn the audio unit off.
  4. NOTE: Turning the ignition switch off and back on may not re-enable the DVD player buttons.
  5. The speaker walk-around test disables the DVD player buttons. To re-enable the DVD player buttons, turn the audio unit off and back on or simultaneously press the audio unit preset buttons 3 and 5 until the headphone symbol lights up on the audio unit display. Simultaneously pressing the audio unit preset buttons 2 and 4 also re-enables the DVD player buttons and changes the system between single play and dual play. In dual play, the rear speakers and subwoofer turn off and the headphone outputs turn on.