All vehicles
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Using the special tool, install a new Teflon® seal on the pressure line-to-pump fitting.
- Position the pressure line and connect the pressure line-to-pump fitting.
- If equipped with a 4.6L or 5.4L engine, tighten to 65 N.m (48 lb-ft).
- If equipped with a 4.2L engine, tighten to 20 N.m (15 lb-ft).
- Connect the power steering pump supply hose and install the clamp.
- Install the power steering pump pulley. For additional information, refer to Power Steering Pump Pulley in this article.
- Fill the power steering system. For additional information, refer to STEERING SYSTEM - GENERAL INFORMATION article.