Exhaust Y-Pipe - Dual Catalytic Converter: Installation: Notes
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do not tighten the fasteners until all components are assembled and aligned, making sure to tighten all fasteners beginning at the front of the vehicle. For additional information, refer to Exhaust System Alignment
.
NOTE:
Clean the mating surfaces of the manifold outlet flare and the catalytic converter inlet flare.
Make sure not to damage the manifold outlet flare, the converter inlet flare or the studs.