Engine Dynamic Balance Shaft: Installation
WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Lubricate the engine dynamic balance shaft with clean engine oil and install it in the engine block.
- Install the bolts.
- Tighten to 11 Nm (8 lb-ft).
- Make sure the engine dynamic balance shaft Woodruff key is at the 12 o'clock position and the camshaft Woodruff key is at the 6 o'clock position.
- Install the engine dynamic balance shaft drive gear on the camshaft. Make sure the timing marks on the drive gear and driven gear are lined up.
- Install the timing drive components. For additional information, refer to Timing Drive Components in this article.