LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 710 (Engine - 4.2L - F-150) >> In-Vehicle Servicing >> Cylinder Head >> Removal >> RH cylinder head

RH cylinder head

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the bolt and the upper idler pulley.
  2. Remove the 4 bolts and position the generator bracket, the generator, the accessory drive belt tensioner and the accessory drive belt idler pulley aside as an assembly.
  3. Remove the bolt and position the radio interference capacitor aside.
  4. Remove the RH exhaust manifold. For additional information, refer to Exhaust Manifold - RH  in this article.
  5. Detach the heated oxygen sensor (HO2S) electrical connector retainer from the rear of the RH cylinder head. Remove the bolt and detach the ground wire.
  6. Remove the push rods from the RH cylinder head. For additional information, refer to Push Rod  in this article.
scientia non olet · About LEMON Manuals