LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 709 (Electronic Engine Control System - F-150 & Mark LT) >> Removal And Installation >> Mass Air Flow (MAF) Sensor - 4.6L (2V) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the clamp on the air cleaner and separate the tray from the cover.
  2. Disconnect the mass air flow (MAF) sensor electrical connector and detach the connector retainer.
  3. Remove the grommet from the air cleaner cover and slide it down the electrical harness.
  4. Pull the air cleaner inner cover and MAF sensor out of the air cleaner cover.
  5. Disconnect the MAF sensor electrical connector and remove the inner cover and MAF sensor assembly.
  6. Remove the bolts and the MAF sensor.
    • To install, tighten to 2 Nm (18 lb-in).
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals