LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 709 (Electronic Engine Control System - F-150 & Mark LT) >> Removal And Installation >> Knock Sensor (KS) - 4.2L >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the bolt and position the fuel tube bracket aside.
  3. Disconnect the knock sensor (KS) electrical connector.
  4. Remove the bolt and the KS.
    • To install, tighten to 20 Nm (15 lb-ft).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals