In-Vehicle Servicing: Flexplate: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Install the flexplate and the 6 bolts. Tighten the bolts in 2 stages in the sequence shown.
- Stage 1: Tighten to 20 Nm (15 lb-ft).
- Stage 2: Tighten to 80 Nm (59 lb-ft).

Fig 1: Identifying Tightening Sequence Of Flexplate Bolts

Courtesy of FORD MOTOR CO.

Install the transmission. For additional information, refer to AUTOMATIC TRANSAXLE/TRANSMISSION - 4R70E/4R75E article.