LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 696 (Engine - 4.6L (2V) - F-150) >> Disassembly And Assembly Of Subassemblies >> Piston >> Assembly

Disassembly And Assembly Of Subassemblies: Piston: Assembly

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The connecting rod must be installed into the piston with identification markings toward the front.
  1. Position the connecting rod in the piston.
    2. Fig 1: Positioning Connecting Rod In Piston
    GF0000360Courtesy of FORD MOTOR CO.
    NOTE: Lubricate the piston pin and retainers with clean engine oil.
  2. Install the piston pin and the 2 piston pin retainers.
    3. NOTE: Lubricate all the piston rings and the piston oil control spacer with clean engine oil.
  3. Install the lower piston oil control segment ring.
  4. Install the piston oil control spacer.
  5. Install the upper piston oil control segment ring.
  6. Install the lower piston compression ring.
  7. Install the upper piston compression ring.
scientia non olet · About LEMON Manuals