LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 675 (Engine Controls - Powertrain DTC Charts And Descriptions (Except Diesel & Hybrid)) >> DTC Diagnosis >> P0481 - Fan 2 Control Circuit

P0481 - Fan 2 Control Circuit

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2007 Mercury Mountaineer, 2007 Mercury Monterey, 2007 Mercury Montego, 2007 Mercury Milan, and 2007 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
P0481 - FAN 2 CONTROL CIRCUIT

Description:  Monitors the HFC primary circuit output from the powertrain control module (PCM). The test fails, when the HFC output is commanded on (grounded) and excessive current draw is detected on the HFC circuit; or when the HFC circuit is commanded off and voltage is not detected on the HFC circuit (the PCM expects to detect VPWR voltage through the high speed FC relay coil to the HFC circuit).
Possible Causes: 
  • Open or short HFC circuit
  • Open VPWR circuit to the high speed FC relay
  • Damaged high speed FC relay
Diagnostic Aids:  When the HFCF PID reads YES, a concern is currently present. An open circuit or short to ground can only be detected when the PCM is not grounding the HFC circuit. A short to voltage can only be detected when the PCM is grounding the HFC circuit. During the key on engine off (KOEO) and key on engine running (KOER) self-test, the HFC circuit is cycled on and off.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All refer to PINPOINT TEST KF .