Roof Opening Panel Glass

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Open the roof opening panel to the VENT position.
Remove the 4 roof opening panel glass screws.
- To access the glass screws, unclip the top portion of the concertina blind and position aside as shown.
- To install, tighten to 6 Nm (53 lb-in).
  
  Fig 1: Locating Roof Opening Panel Glass Screws
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Verify that the roof opening panel is centered and aligned before tightening the screws. For additional information, refer to ROOF OPENING PANEL ALIGNMENT .