LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 659 (Fuel Tank & Lines) >> Removal And Installation >> Inertia Fuel Shutoff (IFS) Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the RH lower A-pillar trim panel.
  2. Disconnect the inertia fuel shutoff (IFS) switch electrical connector
  3. Remove the 2 bolts and the IFS switch.
    • To install, tighten to 2 Nm (18 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals