Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove the RH front fender splash shield. For additional information, refer to FRONT END BODY PANELS .
- Disconnect the windshield washer pump electrical connector.
- Disconnect the washer pump hose.
- Remove the bolt and the windshield washer reservoir filler neck.
- To install, tighten to 7 Nm (62 lb-in).
- Remove the windshield washer reservoir fasteners and the windshield washer reservoir.
- To install, tighten to 7 Nm (62 lb-in).
- To install, reverse the removal procedure.
- Fill the windshield washer reservoir with windshield washer fluid.
WARNING:
Windshield washer solution contains methanol, which is poisonous. Observe all cautions and warnings indicated on the label of the washer solution container. Failure to follow these instructions may result in personal injury.
NOTE:
To prevent spilling windshield washer fluid, drain the windshield washer reservoir before removal.
WARNING:
Windshield washer solution contains methanol, which is poisonous. Observe all cautions and warnings indicated on the label of the washer solution container. Failure to follow these instructions may result in personal injury.
CAUTION:
Do not operate the windshield or rear window washer pumps prior to filling the windshield washer reservoir. Failure to follow these instructions may result in premature pump failure.