LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 645 (Steering Column Switches) >> Removal And Installation >> Steering Column Multifunction Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The instrument panel steering column cover is held in place by tabs that clip to the instrument panel.
  1. Remove the instrument panel steering column cover by pulling straight outward.
    2. NOTE: Release the upper steering column shroud, by pressing inward on the sides of the shroud and lifting upwards.
  2. Remove the upper steering column shroud.
  3. Release the tilt lever, remove the 3 screws and then remove the lower steering column shroud.
  4. Disconnect the multi-function switch electrical connector.
  5. Remove the 2 multi-function switch screws and remove switch.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals