LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Engine System-General Information -- F250-F550 Super Duty (Gasoline)) >> General Procedures >> Valve Seat Width

Valve Seat Width

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the valve seat width. If necessary, grind the valve seat to specification.
    • Measure the intake valve seat width.
    • Measure the exhaust valve seat width.
    • Recheck the valve spring installed length after the seats have been ground, and shim the valve springs as necessary to achieve the correct installed spring length.
    • Refer to the appropriate article for the procedure.
      Fig 1: Measuring Valve Seat Width
      G03919825Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals