LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 609 (Electronic Engine Controls - 2.3L) >> Removal And Installation >> Manifold Absolute Pressure (MAP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the manifold absolute pressure (MAP) sensor electrical connector.
  2. Remove the screw and the MAP sensor.
    • To install, tighten to 3 Nm (27 lb-in).
    3. NOTE: Lubricate the MAP sensor O-ring seal with clean engine oil.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals