LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 609 (Electronic Engine Controls - 2.3L) >> Removal And Installation >> Cylinder Head Temperature (CHT) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Detach the cylinder head temperature (CHT) sensor cover and position aside.
  2. Disconnect the CHT electrical connector.
  3. Remove and discard the CHT.
    • To install, tighten to 12 Nm (9 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals