Rear Brake Caliper: Removal
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING:
Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in personal injury.
CAUTION:
Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Disconnect the parking brake cable from the brake caliper.
- Pull back the parking brake lever.
- Disconnect the cable from the parking brake lever.
- Remove the cable conduit retaining clip.
- Disconnect the cable from the brake caliper.
- Remove the brake caliper flow bolt and position the brake hose aside.
- Discard the 2 copper washers.
- Remove the 2 brake caliper guide bolts and the brake caliper.
- If a leaking or damaged caliper piston boot is found, install a new disc brake caliper.